Who actually carries out the work?

A Gas Safe and, where relevant, OFTEC registered engineer from our own small team carries out the job — we don't sub the install out to a third party after quoting. You deal with the same people from survey through to commissioning and any aftercare calls.

We've still got an old back boiler behind the fireplace — what's involved in removing it?

Removing a back boiler means capping off the gas and water connections behind the fireplace, making good the opening or fitting a new fire/surround if you're keeping one, and rerouting pipework to the new combi or system boiler's position. It's more work than a like-for-like swap but a common upgrade on the older housing stock in this area.

What support do I get after the install is finished?

Once commissioning's complete we talk you through the controls, leave the paperwork, and register the manufacturer warranty on your behalf. If anything doesn't feel right in the first few weeks — a fault code, an odd noise, a control setting you're unsure of — call us during office hours and we'll talk it through or come back out.

Can your van get down our lane, or do we need to arrange something?

Most village lanes we work on are manageable in our vehicles, but if it's single-track, has a low bridge, or turning is tight, mention it when you book so we bring the right size van and allow extra time. It's rarely a reason to turn a job down, just something we plan around.

Our water's not as hard here — do we still need a power flush?

Water hardness affects scale, but sludge from years of corrosion and old radiators builds up regardless of hardness. If your system's been running a long time or you've had cold spots on radiators, a power flush before fitting a new boiler protects it just as much here as anywhere with harder water.

Can you do oil boiler work in Wookey?

Yes — we're OFTEC registered. Wookey has plenty of off-grid properties, so Worcester Heatslave and Grant Vortex installs (with tank swaps where needed) are routine for us.

Wookey's Local Boiler Installation Specialist

Boiler Installation covers a range of jobs, from straightforward like-for-like swaps to full system redesigns with new pipework, controls and hot water storage. The right approach depends on boiler location, flue length, pump speed, radiator sizing and how the property loses heat. As a Gas Safe and OFTEC registered firm and a Worcester Bosch Accredited Installer working out of Radstock, we specify each install against the building rather than fitting a standard package regardless of fit. Typical era of build is mixed-cottage, which affects existing pipework and system cleanliness. Terrain is level, which matters for condensate runs and tank siting. In Wookey itself (BA5, Somerset) that usually means stone cottages and modern infill, roughly 11 miles from the workshop.

07516 118198 Book a service

BA5 · Somerset · 11 mi from Radstock · B3139

Boiler Installation on a village property 11 miles from Radstock, boiler installation in Wookey (BA5) — Somerset

Reading the property before pricing the work

This area has a genuine mix of mains gas and oil-fired properties, sometimes on the same street, depending on when the gas network reached that particular row of houses. It's worth confirming which fuel your property is actually on and whether a fuel switch is realistic before assuming either option is off the table. Being registered for both Gas Safe and OFTEC work means we can look at the honest options for your specific property rather than steering you toward whichever fuel we happen to be set up for. Typical era of build is mixed-cottage, which affects existing pipework and system cleanliness. Terrain is level, which matters for condensate runs and tank siting. Wookey is roughly 11 miles from our Radstock base via the B3139. Typical property stock here: stone cottages and modern infill. A meaningful share of properties around Wookey are off the gas grid, so oil boiler installs and tank swaps make up a fair part of what we do locally. When we quote boiler installation here we factor in flue routing, condensate fall and gas-supply pipe sizing before the price is fixed.

What you get, start to finish

Combi, system & regular boilers
Like-for-like swaps in a single day
Worcester, Vaillant, Ideal, Grant & more
Up to 10-year manufacturer warranties
Free written quote, no obligation
Local aftercare from a 11-mile base

Nearby villages and neighbourhoods

Beyond Wookey we're frequently on jobs in Wookey Hole (BA5), Wells (BA5), Easton (BA5) and Coxley (BA5) — so spares, follow-ups and annual services are straightforward.

Why Wookey households use us

Worcester Bosch Accredited

Qualifies your install for the full 10-year manufacturer guarantee* on supported models.

Fixed written prices

No verbal-only quotes. You'll get the boiler model, controls and warranty in writing before we book.

Local, family-run

Based at 24 Bristol Rd, Radstock — every job is run by the team that quoted it.

Checkatrade 9.9/10

362+ verified reviews from real customers across BA and BS postcodes.

Wookey questions we get asked

Who actually carries out the work?: A Gas Safe and, where relevant, OFTEC registered engineer from our own small team carries out the job — we don't sub the install out to a third party after quoting. You deal with the same people from survey through to commissioning and any aftercare calls.
We've still got an old back boiler behind the fireplace — what's involved in removing it?: Removing a back boiler means capping off the gas and water connections behind the fireplace, making good the opening or fitting a new fire/surround if you're keeping one, and rerouting pipework to the new combi or system boiler's position. It's more work than a like-for-like swap but a common upgrade on the older housing stock in this area.
What support do I get after the install is finished?: Once commissioning's complete we talk you through the controls, leave the paperwork, and register the manufacturer warranty on your behalf. If anything doesn't feel right in the first few weeks — a fault code, an odd noise, a control setting you're unsure of — call us during office hours and we'll talk it through or come back out.
Can your van get down our lane, or do we need to arrange something?: Most village lanes we work on are manageable in our vehicles, but if it's single-track, has a low bridge, or turning is tight, mention it when you book so we bring the right size van and allow extra time. It's rarely a reason to turn a job down, just something we plan around.
Our water's not as hard here — do we still need a power flush?: Water hardness affects scale, but sludge from years of corrosion and old radiators builds up regardless of hardness. If your system's been running a long time or you've had cold spots on radiators, a power flush before fitting a new boiler protects it just as much here as anywhere with harder water.
Can you do oil boiler work in Wookey?: Yes — we're OFTEC registered. Wookey has plenty of off-grid properties, so Worcester Heatslave and Grant Vortex installs (with tank swaps where needed) are routine for us.

Booking work in Wookey

For rural and off-grid properties, boiler installation often involves oil rather than mains gas, so mention your current fuel and tank setup when you call. Being OFTEC registered as well as Gas Safe registered means we can quote for either without treating oil as a specialist add-on. Send the appliance make, model and any fault code and you get a straight answer, not a sales script. Our van runs the B3139 to reach you, 11 miles out from the Radstock workshop. Most of what we open up here is stone cottages and modern infill, which dictates flue routes and pipe sizing.

07516 118198 All services in Wookey

Local reference data

County: Somerset
Postcode district: BA5
Settlement type: village
Nearest classified road: B3139
Distance from our base: 11 miles (Radstock, BA3)
Typical building stock: stone cottages and modern infill
Water hardness: moderately hard water
Fuel availability: mains gas with off-grid pockets
Customer mix: homes alongside small commercial and agricultural premises
Nearby areas covered: Wookey Hole, Wells, Easton, Coxley

Detail that matters in Wookey

Village lane access and van positioning for larger jobs

Village lanes around Wookey are often single-track or tight two-way roads without dedicated off-street loading space, which affects how a larger job like a full system installation or an oil tank replacement is planned — the van needs somewhere to park close enough for repeated trips carrying equipment without blocking the lane for through traffic or farm vehicles. On a job involving a full radiator or pipework replacement, materials sometimes need staging over more than one visit rather than delivered all at once if there's nowhere secure to leave them on-site between visits. We check lane width and passing places when scheduling larger jobs in village locations, and plan van access and parking as part of the job rather than as an afterthought on the day.

Nozzle replacement and baffle cleaning on oil burners

An oil burner's nozzle atomises fuel into a fine spray for combustion, and it wears from constant fuel flow at pressure, gradually changing the spray pattern away from the burner manufacturer's specification even before it visibly fails. A worn nozzle burns less cleanly, producing more soot that coats the heat exchanger's baffles, and a sooted heat exchanger loses efficiency in the same way scale does on a gas boiler's plates. Standard practice on an annual oil service is to replace the nozzle as a matter of course, rather than wait for a fault, and to remove and clean the baffles so the heat exchanger surfaces are exposed to combustion heat properly again. Skipping nozzle replacement to save a service visit's minor parts cost is a false economy against the fuel wasted by a poorly atomising burner.

How a condensing boiler recovers extra heat

A condensing boiler passes flue gases through a secondary heat exchanger before they leave the flue, extracting additional heat by condensing water vapour in the exhaust back into liquid, which is expelled as the mildly acidic condensate water down the drain. This is why every condensing boiler needs a condensate drainage route as part of its installation, unlike older non-condensing boilers, which simply vented hot dry gas straight out. The efficiency benefit only fully materialises when the boiler is actually condensing regularly, which needs a return water temperature low enough — generally below 55°C — for water vapour to condense in the first place. A condensing boiler run permanently at a high flow temperature can spend much of its time not actually condensing, which is one of the main reasons flow temperature settings matter as much as the boiler model chosen.

Radiator sizing after lowering the flow temperature

Running a boiler at a lower flow temperature — typically 55°C or below rather than the old default of 70-80°C — improves condensing efficiency measurably, but it also reduces the heat output of every radiator in the house, because a radiator's output falls roughly with the square of the temperature difference to the room. Radiators sized correctly for a 75°C flow can end up unable to heat the room properly at 55°C unless they're upsized or supplemented. We check each radiator against the lower design flow temperature before recommending it, and where a room falls short we look at whether a larger single panel, a double panel, or an additional radiator on that circuit closes the gap, rather than pushing the flow temperature back up and giving away the efficiency gain.

Choosing a boiler location that satisfies both planning and practicality in Wookey

On a property within a conservation area, AONB or World Heritage designation, the boiler's physical location is often decided as much by the acceptable flue route as by where the homeowner would naturally put it — a kitchen wall facing the street may need ruling out even before considering pipe run length, simply because the flue outlet would be visible from a protected streetscape. Working back from an acceptable flue position to find a viable boiler location sometimes means a longer pipework run through the property than would otherwise be chosen, adding to the job's cost and complexity. We assess planning constraints on the flue before finalising the boiler's proposed location, rather than picking the location first and discovering the flue route is unacceptable afterwards.

Signs a boiler repair is no longer the right call

A boiler that's failing repeatedly, needing a different part replaced every service, or over roughly ten to fifteen years old is approaching the point where continued repair costs more over time than replacement, particularly once a heat exchanger — the most expensive single part — starts to show signs of failure through leaks or reduced output. Efficiency is the other half of the calculation: an older non-condensing boiler running at 70-80% efficiency against a modern condensing combi at over 90% means a meaningful chunk of every unit of fuel burned in the old boiler is simply lost up the flue. We give a straight answer on repair versus replace based on the fault found and the boiler's age and condition, rather than defaulting to whichever is more profitable to us on the day.

Working across Somerset: what being local changes

Being based at 24 Bristol Road, Radstock, 11 miles from Wookey via the B3139, means a callout doesn't involve a long cross-county drive, and it also means familiarity with the recurring patterns in the local building stock — stone cottages and modern infill — rather than encountering that construction type for the first time on-site. Local knowledge doesn't replace a proper site survey, but it does mean fewer surprises: knowing in advance that a particular postcode area typically has hard water, older single-pipe circuits, or restricted parking means the quote reflects the likely reality of the job before the first visit. We're Gas Safe and OFTEC registered and work across Somerset on that basis, not by claiming coverage we don't actually deliver on.

Why a boiler needs a permanently live electrical supply

A boiler's electrical supply has to be permanently live, taken from a fused spur rather than switched off a light circuit or any switch a homeowner might turn off without realising it isolates the boiler along with it. This matters for frost protection especially — a boiler's internal frost thermostat can only bring the system on to prevent freezing if it has power at the time, so a supply that's accidentally switched off overnight defeats frost protection entirely, even though everything else about the installation is correct. We check the existing electrical supply on every boiler swap and, where it's taken from an inappropriate circuit, correct it as part of the installation rather than leaving a known risk in place because it wasn't part of the original job description.

Other boiler services in Wookey

Worcester Bosch Accredited · 10 Year Guarantee*

New Worcester boiler with a 10 year guarantee*

Free no-obligation quotes for installation, servicing & repairs across BA & BS postcodes.

07516 118198 Request a Quote