Do you cover Staverton?

Yes. Staverton is 11 miles from our workshop at 24 Bristol Road, Radstock BA3 3EE, reached via the B3105, and it's a regular part of our working area. We're Gas Safe and OFTEC registered, so we cover both mains gas and oil work out here without treating it as a special trip.

Is oil more expensive to run than mains gas?

Oil and gas prices both move with the wholesale market and neither is fixed, so a blanket answer isn't honest. What we can say is that a modern condensing oil boiler, correctly sized and commissioned, will run considerably more efficiently than an old non-condensing model — that efficiency gap usually matters more than the fuel choice itself.

What actually happens on install day?

The engineer isolates the gas or oil supply and water, removes the old boiler, fits and pressure-tests the new one, connects the flue and condensate, and commissions the system. For a straight swap this is usually one day; a conversion, relocation, or cylinder change can run into a second depending on the pipework involved.

How do you decide whether to repair or replace a boiler?

We weigh the age of the boiler, whether parts are still made for it, how many faults it's had recently, and its running efficiency against a like-for-like or upgraded replacement. If a straightforward part fixes it and the boiler's otherwise sound, we'll say so rather than push a new install you don't need.

How do we decide between a combi boiler and a boiler-plus-cylinder system?

It comes down to hot water demand and available space. A combi heats water on demand with no cylinder to fill, which suits smaller households and single-bathroom homes, while a system or regular boiler with a cylinder stores hot water and copes far better where two bathrooms or a bath and shower run at the same time.

Can you do oil boiler work in Staverton?

Yes — we're OFTEC registered. Staverton has plenty of off-grid properties, so Worcester Heatslave and Grant Vortex installs (with tank swaps where needed) are routine for us.

Local Boiler Installation for Staverton

Before quoting for boiler installation, we start with what's actually there: the existing pipework, the flue route, the water pressure and the age of what you've already got. Guesswork on a heating system leads to call-backs and wasted money, so a proper look at the property comes first. We're Gas Safe registered and OFTEC registered, based at 24 Bristol Road, Radstock BA3 3EE, and we size and specify jobs on what we find on site, not on assumptions. Planning constraints are usually light here, so external work is checked first. Water here is moderately hard water, so scale protection is specified accordingly. In Staverton itself (BA14, Wiltshire) that usually means stone cottages and modern estates, roughly 11 miles from the workshop.

07516 118198 Check availability

BA14 · Wiltshire · 11 mi from Radstock · B3105

Boiler Installation in a mixed-cottage property in Staverton, BA14, boiler installation in Staverton (BA14) — Wiltshire

Why Staverton work is specified differently

This area has a genuine mix of mains gas and oil-fired properties, sometimes on the same street, depending on when the gas network reached that particular row of houses. It's worth confirming which fuel your property is actually on and whether a fuel switch is realistic before assuming either option is off the table. Being registered for both Gas Safe and OFTEC work means we can look at the honest options for your specific property rather than steering you toward whichever fuel we happen to be set up for. Mains gas covers much of the area, with off-grid pockets, which changes the appliance shortlist. homes alongside small commercial and agricultural premises make up most enquiries from this postcode. Staverton is roughly 11 miles from our Radstock base via the B3105. Typical property stock here: stone cottages and modern estates. A meaningful share of properties around Staverton are off the gas grid, so oil boiler installs and tank swaps make up a fair part of what we do locally. When we quote boiler installation here we factor in flue routing, condensate fall and gas-supply pipe sizing before the price is fixed.

Within reach of the B3105

Beyond Staverton we're frequently on jobs in Hilperton (BA14), Bradford on Avon (BA15), Trowbridge (BA14) and Holt (BA14) — so spares, follow-ups and annual services are straightforward.

Included as standard in Staverton

Combi, system & regular boilers
Like-for-like swaps in a single day
Worcester, Vaillant, Ideal, Grant & more
Up to 10-year manufacturer warranties
Free written quote, no obligation
Local aftercare from a 11-mile base

Registrations and how work is signed off

Local, family-run

Based at 24 Bristol Rd, Radstock — every job is run by the team that quoted it.

OFTEC trained

Oil boilers, oil tanks and pipework — fully certified for off-grid installs and replacements.

Fixed written prices

No verbal-only quotes. You'll get the boiler model, controls and warranty in writing before we book.

Checkatrade 9.9/10

362+ verified reviews from real customers across BA and BS postcodes.

Straight answers for Staverton homeowners

Do you cover Staverton?: Yes. Staverton is 11 miles from our workshop at 24 Bristol Road, Radstock BA3 3EE, reached via the B3105, and it's a regular part of our working area. We're Gas Safe and OFTEC registered, so we cover both mains gas and oil work out here without treating it as a special trip.
Is oil more expensive to run than mains gas?: Oil and gas prices both move with the wholesale market and neither is fixed, so a blanket answer isn't honest. What we can say is that a modern condensing oil boiler, correctly sized and commissioned, will run considerably more efficiently than an old non-condensing model — that efficiency gap usually matters more than the fuel choice itself.
What actually happens on install day?: The engineer isolates the gas or oil supply and water, removes the old boiler, fits and pressure-tests the new one, connects the flue and condensate, and commissions the system. For a straight swap this is usually one day; a conversion, relocation, or cylinder change can run into a second depending on the pipework involved.
How do you decide whether to repair or replace a boiler?: We weigh the age of the boiler, whether parts are still made for it, how many faults it's had recently, and its running efficiency against a like-for-like or upgraded replacement. If a straightforward part fixes it and the boiler's otherwise sound, we'll say so rather than push a new install you don't need.
How do we decide between a combi boiler and a boiler-plus-cylinder system?: It comes down to hot water demand and available space. A combi heats water on demand with no cylinder to fill, which suits smaller households and single-bathroom homes, while a system or regular boiler with a cylinder stores hot water and copes far better where two bathrooms or a bath and shower run at the same time.
Can you do oil boiler work in Staverton?: Yes — we're OFTEC registered. Staverton has plenty of off-grid properties, so Worcester Heatslave and Grant Vortex installs (with tank swaps where needed) are routine for us.

Booking work in Staverton

Once we've seen the property, you'll get a written quote for boiler installation that sets out exactly what's included — the equipment, the work, and what happens if anything unexpected turns up once we're on site. That gives you something concrete to compare against any other quotes you're getting. A written quote follows the survey — no pressure, and no charge for the Staverton visit. Terrain is hill top, which matters for condensate runs and tank siting. Most of what we open up here is stone cottages and modern estates, which dictates flue routes and pipe sizing.

07516 118198 All services in Staverton

Area data we work from

County: Wiltshire
Postcode district: BA14
Settlement type: village
Nearest classified road: B3105
Distance from our base: 11 miles (Radstock, BA3)
Typical building stock: stone cottages and modern estates
Water hardness: moderately hard water
Fuel availability: mains gas with off-grid pockets
Customer mix: homes alongside small commercial and agricultural premises
Nearby areas covered: Hilperton, Bradford on Avon, Trowbridge, Holt

The parts of the job people rarely mention

Building Control notification for boiler work

Installing or replacing a boiler is notifiable work under Building Regulations, and a Gas Safe or OFTEC registered installer working within their scheme's competent-person arrangements notifies the local authority electronically on completion, which avoids the homeowner having to apply for Building Regulations approval separately and pay a council fee for it. This generates a compliance certificate that matters at the point of selling the property — conveyancing solicitors routinely ask for it, and its absence can hold up a sale. Work carried out by someone outside a competent-person scheme has to be notified to Building Control directly and inspected, which is slower and often more expensive. We notify every applicable installation as standard and the certificate follows automatically.

Condensate soakaways where there's no convenient drain

Properties without a nearby internal waste connection or external gully for the boiler's condensate — common on rural plots around Staverton where the nearest drain run is a long way from the boiler's location — sometimes need a dedicated condensate soakaway instead. This is a small pit filled with granular material that the condensate, which is mildly acidic, can disperse into gradually rather than running to a drain at all. Sizing and siting it correctly matters: it needs to be far enough from foundations and sited where the local ground can actually absorb the modest but steady volume a boiler produces, particularly over a long heating season. Where ground conditions make a soakaway unreliable, running a longer insulated pipe to a proper drainage connection is usually the safer long-term choice even though it's more work to install.

LPG as an alternative to oil off the gas grid

Properties around Staverton that sit off the mains gas network aren't limited to oil — bulk LPG, stored in an above-ground tank on a concrete base with the same OFTEC-style clearance and access rules as oil, runs standard gas-rated boilers with only a change of injector and pressure setting rather than a different boiler entirely. It suits households that want a gas hob and gas-style modulation rather than an oil burner's on/off firing pattern. The tank still needs delivery access for a tanker, which on some rural driveways is the deciding factor over oil. We check the access route for the largest realistic delivery vehicle before recommending LPG over oil, because a tank that can't be filled easily causes more disruption than the fuel choice was meant to solve.

Boiler interlock: a Part L requirement, not an extra

Building Regulations Part L requires a "boiler interlock" on new and replacement heating systems — wiring arranged so the boiler and pump cannot run unless a room thermostat or a zone valve is actually calling for heat. Without it, a boiler can cycle needlessly even when no zone in the house wants heat, wasting fuel and adding wear. It's a wiring and control logic requirement rather than a specific product, so it can be satisfied by several different control layouts as long as the end result prevents that unwanted firing. We confirm interlock is correctly wired as part of every boiler installation and note it on the commissioning paperwork, because it's one of the checks Building Control or a competent-person scheme inspection will look for specifically.

Heating where a home sits alongside commercial premises

Properties around Staverton that combine living accommodation with an attached shop, workshop or other commercial space often need heating designed as genuinely separate zones with independent controls, since a shop's occupied hours and heating demand rarely match the flat or house above it. Where the two shared a single ageing system, splitting them onto separate zone valves — or, on a larger scale, separate boilers — stops one side subsidising or interfering with the other's heating schedule. Commercial space also sometimes falls under different servicing and safety-record obligations than the residential side, depending on how it's used, so it's worth establishing which parts of the building fall under which regime before assuming a single annual service covers everything.

Chimney liners for boilers using an existing flue

Where an older boiler used the property's original brick or stone chimney as its flue route, a replacement condensing boiler usually can't use the same masonry flue unlined, because the flue gases are cooler and wetter and will attack unprotected brickwork and mortar over time. A correctly specified stainless steel liner, sized to the boiler manufacturer's flue length and diameter tables, carries the flue gases safely and lets the existing chimney be reused rather than needing a new wall or roof penetration — often the only realistic option on a listed or solid-wall property in Staverton where an external flue run isn't permitted. The liner has to be inspected and swept as part of ongoing servicing exactly as an open-fire flue would be, which is easy to overlook once it's hidden inside the chimney.

Other boiler services in Staverton

Worcester Bosch Accredited · 10 Year Guarantee*

New Worcester boiler with a 10 year guarantee*

Free no-obligation quotes for installation, servicing & repairs across BA & BS postcodes.

07516 118198 Request a Quote