What support do I get after the install is finished?

Once commissioning's complete we talk you through the controls, leave the paperwork, and register the manufacturer warranty on your behalf. If anything doesn't feel right in the first few weeks — a fault code, an odd noise, a control setting you're unsure of — call us during office hours and we'll talk it through or come back out.

We're on mains gas — is a boiler swap a fairly simple job?

Where the new boiler goes in the same place with the same flue route, a mains gas swap is usually the most straightforward job we do — often completed within a working day. It gets more involved if you're relocating the boiler, changing from a heat-only or system boiler to a combi, or the existing pipework needs upgrading to suit.

Can you look over a quote I've already had from another company?

Yes, this comes up often. Send or bring in the other written quote and we'll go through the spec — boiler size, controls, cylinder if included, and what's actually listed for parts and labour — and tell you plainly whether it looks right for the property, oversized, or missing something we'd expect to see.

Is a boiler install a noisy, disruptive job?

There's unavoidable noise — drilling for the flue, pipework, sometimes moving a cylinder — but a straightforward swap is usually done within a working day with the mess kept to the immediate work area. We dust-sheet the route in and out and clear away pipe offcuts and old parts before we leave.

What's the difference between a boiler service and general maintenance?

A service is the annual manufacturer-required safety and efficiency check that keeps the warranty valid. Maintenance covers everything else — bleeding radiators, checking system pressure, sorting minor faults, and periodic flushing or filter checks — that keeps the system running well between those annual services rather than replacing them.

What's the warranty on a new boiler installed in Chew Magna?

Up to 10 years on qualifying Worcester Bosch installs registered through us as Accredited Installers. Other manufacturers typically offer 5–7 years.

Chew Magna Boiler Installation

Boiler Installation is something we handle directly from our base at 24 Bristol Road, Radstock BA3 3EE, rather than subcontracting it out. That means one point of contact for the whole job, from the first look at the property through to commissioning and handover. Gas Safe registered, OFTEC registered and a Worcester Bosch Accredited Installer, open Monday to Friday, 8:30am to 5pm on 07516 118198. Terrain is valley floor, which matters for condensate runs and tank siting. Most of what we open up here is stone village homes and georgian houses, which dictates flue routes and pipe sizing. In Chew Magna itself (BS40, North Somerset) that usually means stone village homes and georgian houses, roughly 8 miles from the workshop.

07516 118198 Request your quote

BS40 · North Somerset · 8 mi from Radstock · B3130

Flue and pipework detail from a boiler installation job in North Somerset, boiler installation in Chew Magna (BS40) — valley floor setting

Neighbouring North Somerset areas we serve

Beyond Chew Magna we're frequently on jobs in Chew Stoke (BS40), Stanton Drew (BS39), Winford (BS40) and Compton Martin (BS40) — so spares, follow-ups and annual services are straightforward.

Registrations and how work is signed off

OFTEC trained

Oil boilers, oil tanks and pipework — fully certified for off-grid installs and replacements.

Checkatrade 9.9/10

362+ verified reviews from real customers across BA and BS postcodes.

Local, family-run

Based at 24 Bristol Rd, Radstock — every job is run by the team that quoted it.

Fixed written prices

No verbal-only quotes. You'll get the boiler model, controls and warranty in writing before we book.

Why Chew Magna work is specified differently

The water supply in this part of the Chew Valley and surrounding area is hard, sitting between the very hard limestone water closer to Bath and the moderately hard supply further out. It's still enough to affect scale build-up over time, particularly in hot water cylinders and combi heat exchangers. We take that into account when specifying protection for a new system rather than assuming the same setup that works on a soft-water supply elsewhere in the country will perform the same way here. Terrain is valley floor, which matters for condensate runs and tank siting. Most of what we open up here is stone village homes and georgian houses, which dictates flue routes and pipe sizing. Chew Magna is roughly 8 miles from our Radstock base via the B3130. Typical property stock here: stone village homes and Georgian houses. Mains gas covers most of Chew Magna, so the usual choice is between a modern combi or a system boiler with a cylinder — we'll size it correctly for the home, not just swap like-for-like. When we quote boiler installation here we factor in flue routing, condensate fall and gas-supply pipe sizing before the price is fixed.

Included as standard in Chew Magna

Combi, system & regular boilers
Like-for-like swaps in a single day
Worcester, Vaillant, Ideal, Grant & more
Up to 10-year manufacturer warranties
Free written quote, no obligation
Local aftercare from a 8-mile base

Straight answers for Chew Magna homeowners

What support do I get after the install is finished?: Once commissioning's complete we talk you through the controls, leave the paperwork, and register the manufacturer warranty on your behalf. If anything doesn't feel right in the first few weeks — a fault code, an odd noise, a control setting you're unsure of — call us during office hours and we'll talk it through or come back out.
We're on mains gas — is a boiler swap a fairly simple job?: Where the new boiler goes in the same place with the same flue route, a mains gas swap is usually the most straightforward job we do — often completed within a working day. It gets more involved if you're relocating the boiler, changing from a heat-only or system boiler to a combi, or the existing pipework needs upgrading to suit.
Can you look over a quote I've already had from another company?: Yes, this comes up often. Send or bring in the other written quote and we'll go through the spec — boiler size, controls, cylinder if included, and what's actually listed for parts and labour — and tell you plainly whether it looks right for the property, oversized, or missing something we'd expect to see.
Is a boiler install a noisy, disruptive job?: There's unavoidable noise — drilling for the flue, pipework, sometimes moving a cylinder — but a straightforward swap is usually done within a working day with the mess kept to the immediate work area. We dust-sheet the route in and out and clear away pipe offcuts and old parts before we leave.
What's the difference between a boiler service and general maintenance?: A service is the annual manufacturer-required safety and efficiency check that keeps the warranty valid. Maintenance covers everything else — bleeding radiators, checking system pressure, sorting minor faults, and periodic flushing or filter checks — that keeps the system running well between those annual services rather than replacing them.
What's the warranty on a new boiler installed in Chew Magna?: Up to 10 years on qualifying Worcester Bosch installs registered through us as Accredited Installers. Other manufacturers typically offer 5–7 years.

Next step for Chew Magna

Part of what a written quote for boiler installation gives you is clarity on scope: exactly which pipework, controls and components are included, and which aren't. That clarity is what prevents disputes later, and it's standard practice on every job we quote for. A written quote follows the survey — no pressure, and no charge for the Chew Magna visit. Terrain is valley floor, which matters for condensate runs and tank siting. Mains gas is available across most streets, which changes the appliance shortlist.

07516 118198 All services in Chew Magna

Chew Magna coverage and distances

County: North Somerset
Postcode district: BS40
Settlement type: town
Nearest classified road: B3130
Distance from our base: 8 miles (Radstock, BA3)
Typical building stock: stone village homes and Georgian houses
Water hardness: hard water
Fuel availability: mains gas across most of the area
Customer mix: a mix of owner-occupied and rented homes
Nearby areas covered: Chew Stoke, Stanton Drew, Winford, Compton Martin

Things we check around Chew Magna

What voids or protects a Worcester Bosch extended guarantee

Worcester Bosch's longer guarantee periods on qualifying installations are conditional on the boiler being installed and commissioned by an Accredited Installer, on an annual service being carried out (by any Gas Safe registered engineer, not necessarily the original installer) within the required window each year, and on system water quality being maintained to the standard set out in their published guidance — meaning a system flush at installation, correct inhibitor dosing, and in hard water areas a scale reducer or filter as specified. Missing a single annual service, or installing without the required water treatment, can reduce cover back to the manufacturer's standard guarantee period even if the boiler itself has had no faults. Keeping the Benchmark record and service history together is what lets a claim be assessed quickly if it's ever needed.

Gas pipe sizing and working pressure drop

Swapping to a higher-output combi or adding an extra gas appliance means the existing gas pipe has to be checked against the new total demand, not just the boiler's own rating plate. Gas Safe installation procedures require a working pressure test at the appliance under full load, and IGE/UP/2 tables set the maximum permitted pressure drop over the pipe run length and diameter. A run that was adequate for a 24kW back boiler can be undersized once a modern combi with a larger instantaneous hot water draw is fitted on the same 15mm supply. Where the test shows an unacceptable drop, the fix is upsizing to 22mm or shortening the run — not turning the boiler down, which just masks the underlying restriction.

Flue terminal clearances on tight terraces

Terraced streets like the ones through Chew Magna leave very little wall between neighbouring windows, boundaries and downpipes, and the boiler manufacturer's clearance table has to be satisfied on every measurement, not just the obvious ones. A terminal needs clear space below opening windows, above ground level, away from boundaries with the next property and clear of any plastic guttering that condensate plume could damage. On a narrow frontage this sometimes rules out the room the customer would prefer the boiler in, and the pipework has to run further to a wall that does comply. We measure clearances against the manufacturer's technical instructions before quoting, not after installation, because moving a badly sited flue is expensive work to redo.

Heating outbuildings and annexes within an AONB

Converting an outbuilding to a habitable annexe within the Mendip or Chew Valley AONB around Chew Magna often comes with planning conditions attached to external alterations, which can affect where a flue, condensate pipe or oil tank for the new space is permitted to sit relative to the original building's character. Extending an existing boiler or cylinder to also serve the annexe, rather than installing a second separate system, sometimes avoids adding further visible plant to the property, though it depends on whether the existing system has the capacity and pipe run length to serve the extra space without compromising performance at the main house. We check both the planning constraints and the existing system's spare capacity before recommending whether to extend or install separately.

Oil tank de-sludging: why it's not optional

Oil sitting in a tank for years accumulates water from condensation and fine sediment that settles at the bottom, and over time this forms a sludge layer that can be drawn into the fuel line, particularly when the tank is nearly empty and the outlet pulls from lower in the tank than usual. Sludge blocks fine oil filters and burner nozzles, which shows up as burner lockouts or a boiler that won't fire cleanly rather than as an obvious tank problem. De-sludging drains and cleans the tank base without necessarily removing the whole tank, and it's worth doing when a tank is inherited with a property, before switching to a new boiler, or if lockouts recur despite the filter and nozzle being replaced. It's a preventative job that's cheaper done on schedule than after a burner failure it caused.

Pumped-oil versus gravity feed: does it matter?

Older oil systems sometimes still rely on gravity feed, where the tank sits higher than the burner and oil flows down to it under its own weight; a pumped system uses the burner's internal pump to draw oil up from a tank at any level, including below the boiler. Gravity feed limits where a tank can be sited and is more prone to airlocks if the line runs dry, while a pumped system is more flexible on tank position but needs the pipe run and lift height kept within the burner pump's rated capacity — usually no more than a few metres of lift and a set maximum run length. When we replace an oil boiler we check which type the existing tank and pipework support before assuming a straight swap, because a tank sited for gravity feed may need repositioning or a different pump to suit a modern burner.

Other boiler services in Chew Magna

Worcester Bosch Accredited · 10 Year Guarantee*

New Worcester boiler with a 10 year guarantee*

Free no-obligation quotes for installation, servicing & repairs across BA & BS postcodes.

07516 118198 Request a Quote